Tel：400 008 9119 Login  CN | EN

JBE-2120



Applied to EN standard, connect to the loop, monitoring the fire protection equipment. When the dry contact of the module is closed, fire alarm or supervision signal is sent to the control panel
JBE-2120
Overview
JBE-2120 is an addressable input module designed to operate on a loop of intelligent fire detection and alarm devices with the Jade Bird Europe loop protocol. The module is loop-powered and provides one logic input to the fire detection system controlled by the fire panel. This input is electrically isolated from the loop and can be used for monitoring the state of one normally open dry-contact switch. Input modules are often used to monitor third-party equipment such as a door contact. When the input is activated, the LED turns on and the module reports the event to the fire panel.
The JBE-2120 will notify the control panel if there is a disconnection in the pair of cables which lead to the monitored field equipment.

Technical data
CategoryEN 54-18 input module
Working voltageDC 16-30 V (JBE protocol pulse amplitude)
Connection2-wire JBE communication bus, no polarity
WiringTwisted pair, max. wire section 2.5 mm2
Quiescent current≤0.25mA @24V
Activation current≤1mA @24V
EOL resistor10 kΩ
Working temperature0 to +40℃
Storage temperature-20 to +50℃
Environment Humidity≤ 95% RH (no condensation nor icing)
Addressing methodSoft addressing with tool JBE-AT1, non-volatile
Address range1-200
LED IndicationsStandby:"Input" LED flashes when polled
Constant on when active
Fault:"Input" is off.
Activation:"Input" is constantly on.
Dimensions85 mm ×85 mm x41 mm
Weight0.1 kg (including base)
IP ratingIP40
StandardsEn 54-18:2005+AC:2007
Declaration of Perf.DoP-0370-CPR-3805-1
 
Installation
Always observe local fire and electric installation regulations.
1.Secure the base to the wall (surface or flush mounted).
2.Connect the wiring to the base as per the following diagram.
3.Program an unused loop address (1 to 200) to the module using the JBE-AT1 tool.
4.Insert the module into its base and push firmly.
5.Register the moduleinto the fire panel’s configuration.
6.Test wiring integrity after installation. 

Mechanical dimensions
Mechanical dimensions (all dimensions in mm) and connection diagram
TerminalsConnection
4&5Signal loop L1, L2 (no polarity)
9&10Connect equipment in the field: AS+, AS-.
Install the 10 kΩ resistor (provided with the unit) at the furthest end of the cable, in parallel to the NO switch in the field equipment that is monitored.






 
 
About Us
Company Profile
Company Culture
Create Miracle
Product
FW511
FW122R
FW962R
JTY-GD-JBF5100
Case
Domestic case
Foreign case
Service
Pre-sales
During-sales
After-sales
News
Foreign news
Domestic news
Download
Download
Video
Contact Us
Online Message
Foreign distributors
Domestic distributors
Suggestions
Privacy security |Website map |Legal statement |Information
Copyright © 2019 青鸟消防股份有限公司 冀ICP备10006876号-2